990DSL
Users Guide
3-8
2. To change the value of a test-specific parameter, complete the following:
a) Press F or H to select the value you want to change. Press A(
Edit).
The tester is now in Edit mode.
Note
Consult Table 3-2, which provides some helpful tips for
operating the tester in Edit mode.
b) Do the following:
• If the parameter you want to change has a fixed group of choices,
press F or H until the desired choice appears in the field. Then,
press L to save the selection.
OR
• If the parameter has an alphanumeric field, a blinking cursor
appears on the first (left-most) character in the field. To change
the parameter’s value, use the keypad to type the new value. As
you type each character, it appears in the field and the cursor
advances to the next position, allowing you type the next
character. When you finish, press L to save the change.
To Next Page
Loading...
