Fluke 990DSL - Safety Information

Introduction
Introduction
1
1-5
Automated dial-up testing that is compatible with a variety of central office
(C.O.) tone-sending equipment
• Full TDR capability with Auto-Test waveform interpretation software
• Tracing Tone, Monitor, and a fully integrated Dial Set operation
• Caller ID and automatic number ID (ANI) tests
• Non-intrusive “footprint analysis” of service types on working pairs
Safety Information
The CopperPro is intended for use by qualified personnel only. The tester is
designed for use with circuits that have a maximum of 350 VDC or peak AC,
line-to-line or line-to-ground. Do not move the CopperPro from pair to pair
while in a continuous testing mode, to prevent damage to the unit.
The following general safety precautions must be observed during all phases of
operation, service, or repair of the CopperPro. Failure to comply with these
precautions or with specific warnings in this guide violates the safety standards
of design, manufacture, and intended use of the tester. Fluke Networks
assumes no liability for the customer’s failure to comply with these
requirements.
WWarnings
• If this product is used in a manner not specified by the
manufacturer, the protections provided by the product
may be impaired.
• Never connect the CopperPro to a circuit when lightning
storms are nearby.
• Do not open the case. There are no user-serviceable parts
inside.