Fluke 990DSL - Connecting to a Printer; Connecting to a PC

Controls and Connections
Connecting the CopperPro
2
2-9
Connecting to a Printer
To connect the CopperPro to a serial graphics printer, do the following:
1. Attach the nine-pin female connector on the optional printer cable to the
CopperPro D-Sub connector.
2. Attach the nine-pin male cable connector to the printer.
Connecting to a PC
If the CopperPro is connected to a PC, you can download and upload files and
control the tester remotely from the PC. To connect the CopperPro to a PC, do
the following:
1. Attach one end of the supplied RS-232 cable to the RS-232 port, which is
located on the tester’s side panel (Figure 2-1).
2. Attach the other end of the supplied RS-232 cable to an available port on
the PC.