990DSL
Users Guide
2-8
Connecting the CopperPro
This section shows you how to connect the CopperPro to AC power, an
automobile battery, a printer, and a PC.
Connecting to AC Power
When the tester is connected to AC power, you can use the power supply as a
continuous power source. In this way, you can test for long periods of time
without depleting the tester’s batteries.
To connect the CopperPro to AC power, follow these steps:
1. Plug the AC power cord into an AC outlet.
2. Connect the power cord DC Barrel plug into the DC connector. This
connector is located on the tester’s side panel (see Figure 2-1).
3. Do one of the following:
• Turn off the tester to begin charging (see “Charging the Battery” for
details).
• Turn on the tester and begin using.
Connecting to an Automobile Battery
To connect the CopperPro to a 12 VDC automobile battery, follow these steps:
1. Plug the male cigarette lighter plug on the Vehicle Power Cord into the
vehicle lighter socket.
2. Connect the DC barrel plug on the Vehicle Power Cord into the DC
connector. This connector is located on the tester’s side panel (see Figure
2-1).
3. Do one of the following:
• Turn off the tester to begin charging.
• Turn on the tester to begin using.
To Next Page
Loading...
