990DSL
Users Guide
5-24
3. If the selection is correct, press the
Okay softkey to return to the
primary
Ping Setups screen.
4. During the Ping test, a selectable number of data packets is sent to the
target address, with a default of 4 packets. To send a different
number, highlight the
Packets field and edit it to display the desired
number (1 to 30).
5. Highlight the
Connection field. Then, using the Edit function, scroll
to and select the desired connection type for the line under test:
• PPPoE
• PPPoE / Static IP
• Static IP
• DHCP
• PPPoA
6. Press the More softkey to display the secondary Ping Setups screen.
Using the
Edit function, complete the required setups for the selected
connection type (see Table 5-3 for descriptions of setup parameters).
7. After entering all of the required secondary
Ping Setups, press the
BACK key to return to the Ping Status screen.
8. Press
TEST to perform the network Ping operation.
Figure 5-12 shows the results of a Ping operation on a typical ADSL2+ line.
To Next Page
Loading...
