Fuji Xerox Color 550

5 Tools
120
Tools
5
Maintenance
You can delete data from the hard disk of the machine.
Initialize Hard Disk
This feature cannot be used on this machine.
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. By executing [Start], all data registered on the
machine is deleted.
Do not use this feature normally.
Software Options
This feature is for service representative use. For more information, contact your local Fuji
Xerox representative.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up.
If any abnormal condition such as intentional program modification is found during the
program diagnosis, the machine stops starting up and records the information in the audit log.
Note • The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact your local Fuji Xerox representative.
Alignment Adjustment
Adjust settings for printed images (position of image, scaling, squareness (rhombic
transformation), and tilt extent). You can adjust up to 20 configuration sets and assign them
to different trays.
Use this feature to align the positions of images printed on sides 1 and 2 when you want to
add crop marks or cut printouts.
Alignment Adjustment Type Setup
You can create up to 20 configuration sets based, for example, on paper type.
For information on how to configure the sets, refer to "Alignment Adjustment Settings" (P.282).
z
Name
Select a name for the configuration set.
z
X Print Position
Adjust the horizontal position of the image in relation to the paper feed direction in 0.1 mm
increments for sides 1 and 2 separately.
Specify a positive value to move the image in the direction opposite the paper feed, and
specify a negative value to move the image in the same direction as the paper feed.
z
Y Print Position
Adjust the vertical position of the image in relation to the paper feed direction in 0.1 mm
increments for sides 1 and 2 separately.
Specify a positive value to move the image in the direction towards the rear of the machine,
and specify a negative value to move the image in the direction towards the front of the
machine.