Error Code
195
Problem Solving
7
Error Code
This section describes error codes.
An error message and error code (∗∗∗-∗∗∗) are displayed if printing terminated
abnormally because of an error, or a malfunction occurred in the machine.
Refer to the error codes in the following table to resolve problems.
Important • If an error code is displayed, any print data remaining in the machine and information stored
in the machine's memory is not secured.
If an error code is displayed that is not listed in the following table, or if you cannot
resolve an error despite following the instructions described in the table, contact your
local Fuji Xerox representative. The contact number is printed on the label or card
attached to the machine.
Error Code Cause and Remedy
002-770
[Cause] Unable to process job template due to insufficient hard disk space.
[Remedy] Remove unnecessary data from the hard disk to increase free disk space.
003-311
003-318
003-319
003-320
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the same message is displayed again, contact
your local Fuji Xerox representative.
* If you cannot resolve an error despite following the instructions described in the table, contact your local Fuji Xerox
representative. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
