7 Problem Solving
196
Problem Solving
7
003-700
[Cause] Too many documents are set in the document feeder after clearing the paper jam.
[Remedy] Check the output, and then replace the documents that have not been copied yet.
003-701
[Cause] A digital code is embedded in the document to restrict duplication.
[Remedy] Use a document in which no digital code is embedded.
003-702
[Cause] When copying both sides of a document, the [Reduce/Enlarge] setting for side 1
and side 2 differ.
[Remedy] Make sure that the settings are the same for both sides of the document.
003-703
[Cause] Unable to detect the calibration chart for color scanning.
[Remedy] Set the calibration chart correctly.
003-704
[Cause] An abnormal calibration pattern for color scanning was detected. There may be a
malfunction with the machine.
[Remedy] If the problem is not resolved even after trying calibration again, contact your local
Fuji Xerox representative.
003-705
[Cause] When changing the paper size for the tray loaded with paper during Energy Saver
mode, a copy job was started before the machine was able to detect the change in
paper size after recovering from Energy Saver mode.
[Remedy] Cancel copying and perform the copy procedure again.
003-750
[Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "3 Copy" > "Layout Adjustment" in the User Guide.
003-751
[Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
003-752
[Cause] A mix sized document was to be scanned at 600 dpi in Color/2 sided.
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753
[Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
003-755
[Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-757
[Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document again.
003-760
[Cause] An incompatible combination of feature is specified for document scan conditions.
[Remedy] Confirm the selected options.
003-761
[Cause] The paper size of the tray selected for auto tray differs from the paper size of the
tray selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority] settings.
003-763
[Cause] An error occurred when reading the Calibration Chart.
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.79).
003-780
[Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to decrease the data size,
or split the data to send it separately.
003-795
[Cause] When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
[Remedy] Take one of the following measures:
z
Manually enter a reduction/enlargement ratio.
z
Change the paper size.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact your local Fuji Xerox
representative. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
