Fuji Xerox Color 550

8 Appendix
298
Appendix
8
3 Select the tray in which you loaded paper,
and press the <Start> button.
A sample printout is printed.
4 Press [Save].
5 Check the printed sample printout, and measure the A and B fold position movement
amounts.
6 Enter the measurement values you obtained
in Step 5 in [Values A & B Before
Adjustment], and the final value you want
after adjustment in [Desired Values A & B].
Important • Set value A and value B so that an edge
of the paper does not extend past a fold
position of the paper. An edge of paper
extending past a fold position of the paper
may cause a paper jam.
7 Press [Adjust].
8 Press [Sample Printout] again to print a sample printout, and check the adjustment
results.
9 Make adjustments again if necessary. (Step 6)
10 Press [Save].
Z Fold Half Sheet Position Adjustment
Adjust the Z Fold Half Sheet position.
1 Select [Z Fold Half Sheet- A3 ], [Z Fold Half
Sheet- B4 ], [Z Fold Half Sheet-11 x 17" ],
or [Z Fold Half Sheet - 8K ], and press
[Change Settings].