8 Appendix
300
Appendix
8
Adjust Image Transfer
This section describes adjusting image transfer.
You can adjust the transfer output value when image transfer is poor.
Image Transfer Adjustment
Adjust the transfer output value for each paper type.
1 Load the paper for adjusting the transfer output value in the bypass tray.
2 Press the <Log In/Out> button, and enter the
System Administrator Mode.
3 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a password is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is “11111”.
• The default passcode is “x-admin”.
4 Select [Tools] on the [Services Home]
screen.
5 Select [System Settings] > [Common
Service Settings] > [Maintenance].
To Next Page
Loading...
