Correcting the Curl of Outputs (When Finisher D4 or Finisher D4 with Booklet Maker is Installed)
269
Problem Solving
7
Correcting the Curl of Outputs (When Finisher D4 or Finisher D4
with Booklet Maker is Installed)
You can correct the curling of the output by pressing the De-curl button.
The De-curl button functions when the machine is in operation or idle as long as its
power is on.
Note • To change the curling correction mode while the machine is in operation, press the De-curl
button and then the change will be applied immediately.
• Pressing the <Clear All> button on the control panel will not change the curling correction
mode.
1 Check the direction of the curl of the output
copy.
2 Check that the De-curl button is lit.
Note • When the machine is switched on, the
curl correction mode is set to Auto.
• When Power Save is canceled, the curl
correction mode is set to Auto.
3 Press the De-curl button.
Note • Pressing the De-curl button switches between the AUTO, ON, and OFF modes.
For more information, refer to "Modes and Functions of the <De-curl> Button" (P.270).
Upward Curling
Downward Curling
To Next Page
Loading...
