7 Problem Solving
262
Problem Solving
7
5 Pull up the metal part of the staple cartridge
as shown in the illustration.
6 Remove the jammed staples (1), and then
return the metal part pulled up in Step 5 to its
original position (2).
7 Insert the staple cartridge while gripping the
orange lever until you hear it click into place.
8 Close the finisher front cover.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher
is even slightly open.
If you cannot remove jammed staples even after you perform the above procedure,
contact your local Fuji Xerox representative.
Staple Jams in the Booklet Staple Cartridge (For Finisher C2 with Booklet
Maker)
The following describes how to clear a staple jam that occurred in the staple cartridge
of the Finisher C2 with Booklet Maker (optional).
1 Make sure that the machine is not operating,
and open the finisher front cover.
To Next Page
Loading...
