Fuji Xerox Color 550

2 Paper and Other Media
40
Paper and Other Media
2
Changing the Paper Size
This section describes how to change the paper size in Trays 1, 2, 3, 4, 6, and 7.
Note • The types of paper in Trays 1 to 4, 6, and 7 are preset. Normally, Trays 1, 2, 3, 4, 6 and 7
are set to plain paper. When changing to a different paper type, change the paper quality
settings to match the type of paper to be loaded so that you can maintain high quality
printing.
For more information on paper type settings, refer to "Changing the Paper Settings" (P.47).
• Non-standard size paper can be loaded in Trays 1 and 2. When loading non-standard size
paper, you must register the paper size. For information on registering paper sizes, refer to
"Paper Size" (P.114).
For more information on corresponding paper sizes, refer to "Paper Tray Settings" (P.113).
For more information on how to copy on non-standard size paper, refer to "3 Copy" > "Copy" > "Paper
Supply (Selecting the Paper for Copying)" in the User Guide.
Important • Do not load paper of mixed sizes together into a tray.
Changing the Paper Size for Trays 1 and 2
The following describes how to change paper size in Trays 1 and 2.
Note • The types of paper in Trays 1 and 2 are preset. The available preset paper types are: Plain,
Recycled, Plain Reload, Punched, Letterhead, Transparency, Heavyweight, HW Reload,
Extra-HW, X-HW Reload, Hole Punched HW 1, Hole Punched HW 2, Gloss, Gloss Reload,
Heavyweight Gloss, HW Gloss Reload, Labels, Heavyweight Labels, Tab Stock, HW Tab
Stock, Pre-Printed, Custom 1 to 5, and normally, plain paper is set. When changing to a
different paper type, change the paper quality settings to match the type of paper to be
loaded so that you can maintain high quality printing.
For more information on paper type settings, refer to "Changing the Paper Settings" (P.47).
• Non-standard size paper can be loaded in Trays 1 and 2. When loading non-standard size
paper, you must register the paper size. For information on registering paper sizes, refer to
"Paper Tray Attributes" (P.113).
For more information on supported paper sizes, refer to "Paper Size Settings" (P.126).
For more information on how to copy on non-standard size paper, refer to "3 Copy" > "Copy" > "Paper
Supply (Selecting the Paper for Copying)" in the User Guide.
1 Pull out the tray until it stops.
Important • While the machine is processing a job, do
not pull out the tray that is being used for
job.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do
not add paper on top of any remaining paper in the tray.
2 Remove any paper loaded in the tray.
CAUTION
Be sure to pull out the paper tray slowly. If
pulled out with too much force, the tray
may hit and injure your knees or other
parts of your body.