Authentication/Security Settings
159
Tools
5
For more information about Passcode Entry from Control Panel, refer to "Passcode Policy" (P.162).
1 Select [System Administrator’s Passcode].
2 Select [New Passcode].
3 Enter a new passcode (4 to 12 digits) using
the keyboard displayed, and then select
[Save].
Note • If no passcode is set, leave the text boxes
blank and select [Save].
4 Select [Retype Passcode], enter the same
passcode, and then select [Save].
5 Select [Save].
6 A confirmation window appears. Select [Yes] to confirm your entry.
Authentication
In [Authentication], you can set the following items.
The following shows the reference section for each setting.
Login Type ............................................................................................................................... 159
Access Control ......................................................................................................................... 159
Create/View User Accounts..................................................................................................... 160
Reset User Accounts ................................................................................................................ 161
Create Authorization Groups ................................................................................................... 161
User Details Setup.................................................................................................................... 161
Maximum Login Attempts by System Administrator.............................................................. 162
Passcode Policy........................................................................................................................ 162
Charge/Private Print Settings ...................................................................................................162
Login Type
Allows you to select a type of authentication.
No Login Required
Does not use the Authentication feature.
Login to Local Accounts
Authenticates users based on the user information registered on the machine.
To enable printing via a print server when [Login to Local Accounts] is selected, set [Print
Service] in [Auditron Mode] to [Disable Accounting].
Note • When [Login to Local Accounts] is selected, the machine enters the Login mode and [Login]
is displayed at the lower left of the [Services Home] screen.
Login to Remote Accounts
This feature cannot be used on this machine.
Access Control
Allows you to restrict access to the machine or each service. Once the access control
is enabled, user authentication is required to use the machine or the services.
To Next Page
Loading...
