Fuji Xerox Color 550

Loading Paper
33
Paper and Other Media
2
• To prevent paper jams or misloading, do not load new paper into the tray until the tray is
empty. Remove any paper remaining in the tray and then load the paper on newly loaded
paper.
2 Remove any paper loaded on the tray.
3 Load a stack of paper (approximately 100 to
500 sheets) and align the edge of the paper
against the right edge of the tray with the
side to be copied or printed on facing up (1).
Move the long-side paper guide while
holding the grip so that they lightly contact
the edges of the paper (2).
4 Load the remaining paper and align the edge
of the paper against the right edge of the tray
with the side to be copied or printed on
facing up (1). Move the left short-side paper
guide while holding the grip so that they
lightly contact the edges of the paper (2).
Important • Do not load paper exceeding the
maximum fill line. It may cause paper
jams or machine malfunctions.
• If the paper stack loaded in the tray is 100
sheets or less, the guides apply more
pressure to the paper stack. It may cause distortion of paper stack, and may cause paper
jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly and cause paper jams.
5 Push the tray in gently until it comes to a stop.
Loading Tab Paper in Trays 6 and 7 (High Capacity Feeder C1-DS)
The following describes the procedure for loading tab paper in optional Trays 6 and 7
(High Capacity Feeder C1-DS).
Important • Tab paper can be used only for [Tab Margin Shift], and [Covers/Separators].
Note • Be sure to fan the paper well. Otherwise, paper may cause paper jams, and multiple sheets
may be fed to the printer at once.
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Trays 6 and 7 (High Capacity Feeder C1-DS)" (P.46).
When heavyweight paper is loaded in the tray, be sure to make adjustment of the position of the weight
switch buttons. For more information, refer to "Facilitating Feeding of Heavyweight Paper Loaded in
Trays 6 and 7 (High Capacity Feeder C1-DS)" (P.36).
The [Paper Tray Attributes] screen is displayed when you load paper in a tray. For more information,
refer to "Paper Tray Attributes" (P.113).