Fuji Xerox Color 550

2 Paper and Other Media
36
Paper and Other Media
2
5 Load the remaining paper and align the edge
of the paper against the right edge of the tray
with the side to be copied or printed on
facing up (1). Move the left short-side paper
guide while holding the grip so that they
lightly contact the edges of the paper (2).
Note • Do not load paper exceeding the
maximum fill line. It may cause paper
jams or machine malfunctions.
• If the paper stack loaded in the tray is 100
sheets or less, the guides apply more
pressure to the paper stack. It may cause distortion of paper stack, and may cause paper
jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly and cause paper jams.
6 Push the tray in gently until it comes to a stop.
Note • When removing the Postcard Kit, unscrew the screw completely and remove the guide.
Store the removed guide in a place you can easily remember.
Facilitating Feeding of Heavyweight Paper Loaded in Trays 6 and 7 (High
Capacity Feeder C1-DS)
The following describes how to make it easier to feed heavyweight paper loaded in
Trays 6 and 7 (High Capacity Feeder C1-DS).
Use the weight switches to adjust the air assist level. This helps the paper to be fed
smoothly. For the paper heavier than 256 gsm, slide the switch button to the heavier
weight group.
Important • If 256 gsm or heavier paper is loaded in the tray, be sure to switch the button to the heavier
weight group. Otherwise, paper jams or malfunctions may occur.
1 Pull out the tray towards you until it stops.
Important • While the machine processes a job, do
not pull the tray out that the job uses.
2 Slide the switches to the appropriate weight
setting.
3 Push the tray in gently until it comes to a stop.
CAUTION
Be sure to pull out the paper tray slowly. If
pulled out with too much force, the tray
may hit and injure your knees or other
parts of your body.