3 Maintenance
70
Maintenance
3
5 Push a new staple cartridge into the unit.
6 Push the removed unit back to its original
position.
7 Close the right cover of the finisher.
Note • A message will be displayed and the machine will not operate if the right cover of the finisher
is even slightly open.
Replacing the Booklet Staple Cartridge (For Finisher D4 with Booklet
Maker)
When the Finisher D4 with Booklet Maker (optional) is installed and the booklet staple
cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, replace the booklet staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Note • If the booklet staple cartridge is not replaced properly, the message prompting replacement
will remain displayed. In this case, set the new booklet staple cartridge again by performing
the following procedure one more time from the beginning.
• To order a staple cartridge, contact your local Fuji Xerox representative.
1 Make sure that the machine is not operating,
and open the right cover of the finisher.
To Next Page
Loading...
