Adjust Fold Position
291
Appendix
8
Adjust Fold Position
This section describes adjusting the fold position. You can adjust the fold position for
each paper type, and set the adjustment value to any of 10 types. You can assign the
set type to each tray.
You can adjust the fold position for single fold, booklet, C fold, Z fold, and Z fold half
sheet.
Fold Position Adjustment
1
Load the paper for adjusting the fold position in the tray.
2 Press the <Log In/Out> button, and enter the
System Administrator Mode.
For details on entering the System Administrator
Mode, refer to "System Settings Procedure" (P.98).
3 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a password is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is “11111”.
• The default passcode is “x-admin”.
4 Select [Tools] on the [Services Home]
screen.
5 Select [System Settings] > [Common
Service Settings] > [Maintenance].
To Next Page
Loading...
