Replacing Consumables
69
Maintenance
3
Replacing the Staple Cartridge (For Finisher D4 or Finisher D4 with
Booklet Maker)
When the Finisher D4 (optional) or Finisher D4 with Booklet Maker (optional) is
installed and it is time to replace the staple cartridge, a message appears on the touch
screen. When this message appears, replace the staple cartridge.
For remedies if the staple cartridge happened to come off the holder during replacement work, refer to
"Re-inserting the Staple Cartridge into the Cartridge Unit" (P.267).
Important • The use of staples not recommended by Fuji Xerox may degrade quality and performance.
Use only staples recommended by Fuji Xerox.
Note • If the staple cartridge is not replaced properly, the message prompting replacement will
remain displayed. In this case, set the new staple cartridge again by performing the following
procedure one more time from the beginning.
• To order a staple cartridge, contact your local Fuji Xerox representative.
1 Make sure that the machine is not operating,
and open the right cover of the finisher.
2 Hold unit R1 located at the position shown in
the illustration.
3 Pull out the unit.
4 Hold the position indicated by the arrow to
remove the staple cartridge from the unit.
To Next Page
Loading...
