Fuji Xerox Color 550

Machine Trouble
181
Problem Solving
7
Machine Trouble
Before you conclude that the machine is defective, check the machine status again.
Symptom Cause Remedy
The machine is
not powered on.
Is the main power and
power switched on?
Switch the main power switch and power
on.
Refer to "2 Product Overview" in the User
Guide.
Is the power cord plugged
into the power outlet?
Switch the main power switch and power
off, and then firmly plug the power cord into
the connector of the machine and power
outlet. Then switch the main power and
power on.
Refer to "2 Product Overview" in the User
Guide.
Is the power cord
disconnected from the
machine or the back of the
rack?
Does the AC outlet supply
power properly?
Connect another appliance to the outlet to
verify the power supply.
The <Error>
indicator is
blinking.
The system of the machine
or the components installed
may have a trouble.
Switch the main power and power off and
then on. If the error still is not resolved,
contact your local Fuji Xerox
representative.
The <Error>
indicator is lit.
Is paper or a document
jammed?
Remove the jammed paper or document.
If paper is jammed, refer to "Paper Jams"
(P.220), and a document is jammed, refer to
"Document Jams" (P.257).
Is the front cover or top
cover open?
Solve the problem by following the
message displayed.
The touch screen
is too dark.
Is the <Energy Saver>
button lit?
The machine is in the Energy Saver mode.
Press the <Energy Saver> button on the
control panel to exit the Energy Saver
mode.
Refer to "2 Product Overview" in the User
Guide.
Is the screen brightness too
low?
Adjust the screen brightness on the
[Screen Brightness] screen.
Refer to "Adjusting Screen Brightness" (P.21).
Unable to copy. Is a message displayed on
the touch screen?
Follow the instructions displayed to resolve
the problem.
Is the power cord
disconnected from the
machine?
Turn the power switch off, and then firmly
plug the power cord into the connector and
power outlet. Then turn the power switch
on.
Refer to "2 Product Overview" > "Power
Source" in the User Guide.
Is the power breaker switch
on the side of Tray 6 (A4
High Capacity Feeder)
turned off?
Turn on the power breaker switch.
Refer to "2 Product Overview" in the User
Guide.