Error Code
219
Problem Solving
7
Other Errors
This section describes the remedies when the following messages are displayed.
Error
Message
Cause and Remedy
A fault has
occurred.
Switch off the
machine.
(xxx-yyy)
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch the machine power on again.
If the message persists, record the content displayed for [(xxx-yyy)]. Then
immediately switch the main power and power off, make sure that the touch
screen is blank, and then contact your local Fuji Xerox representative.
Completed with
an error.
(xxx-yyy)
[Cause] An error occurred, and the operation terminated abnormally.
[Remedy] Execute the operation again.
A fault has
occurred. The
machine has
rebooted.
Select [Close].
If the problem
persists, call for
service.
(xxx-yyy)
[Cause] An auto-recoverable internal error occurred, and the machine restarted
automatically.
[Remedy] Select [Close]. to use the machine normally. If the error still is not resolved,
contact your local Fuji Xerox representative.
To Next Page
Loading...
