Replacing Consumables
67
Maintenance
3
5 Prepare a new staple case. Insert the front of
the staple case into the staple cartridge (1),
and push down the rear of the case (2).
6 Insert the staple cartridge while gripping the
orange lever until you hear it click into place.
7 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher
is even slightly open.
Replacing the Booklet Staple Cartridge (For Finisher C2 with Booklet
Maker)
When the Finisher C2 with Booklet Maker (optional) is installed and it is time to replace
the booklet staple cartridge, a message appears on the touch screen. When this
message appears, replace the booklet staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade image quality
and performance. Use only staple cartridges recommended by Fuji Xerox.
Note • If the booklet staple cartridge is not replaced properly, the message prompting replacement
will remain displayed. In this case, set the new booklet staple cartridge again by performing
the following procedure one more time from the beginning.
• To order a staple cartridge, contact your local Fuji Xerox representative.
1 Make sure that the machine is not operating,
and open the front cover of the finisher.
1
2
Orange lever
To Next Page
Loading...
