3 Maintenance
68
Maintenance
3
2 While pressing the lever for R2 R3 to the
right (1), pull the staple cartridge unit out of
the machine (2).
3 Hold the staple cartridge by the tabs on both
sides and lift the cartridge out of the unit.
4 While holding the tabs of the new staple
cartridge, push the cartridge into the unit.
Lightly push the cartridge down until you
hear it click into place.
5 Push the staple cartridge unit into its original
position.
6 Close the front cover of the finisher.
Note • A message will be displayed and the machine will not operate if the front cover of the finisher
is even slightly open.
To Next Page
Loading...
