3 Maintenance
72
Maintenance
3
Emptying the Punch Waste Container (For Finisher C2 or Finisher C2 with
Booklet Maker)
When the Finisher C2 (optional) or Finisher C2 with Booklet Maker (optional) is
installed and the punch waste container becomes full, a message appears on the touch
screen. Discard the waste according to the message.
If you take the punch waste container out of the machine, make sure to empty it
completely. If it is reinstalled with some waste remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the punch waste container, make sure that the machine is switched on. If
not switched on, the machine will not recognize that the punch waste container has been
emptied.
• When the machine is in the Energy Saver mode, press the <Energy Saver> button before
emptying the punch waste container and deactivate the Energy Saver mode.
• When emptying the punch waste container, even if the control panel is lit, make sure to
press the <Machine Status> button for accurate information on the punch waste container
status.
1 Make sure that the machine is not operating,
and open the front cover of the finisher.
2 Pull out punch waste container R4 towards
you.
3 Discard all waste.
To Next Page
Loading...
