Fuji Xerox Color 550

2 Paper and Other Media
34
Paper and Other Media
2
1 Pull out the tray towards you until it stops.
Important • While the machine processes a job, do
not pull the tray out that the job uses.
• To prevent paper jams or misloading, do not load new paper into the tray until the tray is
empty. Remove any paper remaining in the tray and then load the paper on newly loaded
paper.
2 Remove any paper loaded on the tray.
3 Load a stack of paper (approximately 100 to
500 sheets) and align the edge of the paper
against the right edge of the tray with the
side to be copied or printed on facing up (1).
Move the long-side paper guide while
holding the grip so that they lightly contact
the edges of the paper (2).
Important • When loading tab paper, position the side
with the tab facing the left short-side
paper guide.
4 Load the remaining paper and align the edge
of the paper against the right edge of the tray
with the side to be copied or printed on
facing up (1). Move the left short-side paper
guide while holding the grip so that they
lightly contact the edges of the paper (2).
Important • Do not load paper exceeding the
maximum fill line. It may cause paper
jams or machine malfunctions.
• If the paper stack loaded in the tray is 100
sheets or less, the guides apply more
pressure to the paper stack. It may cause distortion of paper stack, and may cause paper
jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly and cause paper jams.
5 Push the tray in gently until it comes to a stop.
CAUTION
Be sure to pull out the paper tray slowly. If
pulled out with too much force, the tray
may hit and injure your knees or other
parts of your body.