Error Code
217
Problem Solving
7
124-380
124-381
124-382
124-383
124-390
124-391
124-392
124-393
[Cause] An error occurred
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error is not resolved, contact your local Fuji
Xerox representative.
124-701
[Cause] The output destination was changed because of the malfunction of the specified
output tray (Side Tray).
[Remedy] Contact your local Fuji Xerox representative. You can use any output trays other
than the defective output tray.
124-702
[Cause] The output destination was changed because of the malfunction of the specified
output tray (Finisher Tray).
[Remedy] Contact your local Fuji Xerox representative. You can use any output trays other
than the defective output tray.
124-705
[Cause] The punch setting was canceled.
[Remedy] Confirm the punch position, and then execute the operation again.
124-706
[Cause] The folding setting was canceled.
[Remedy] Confirm the folding setting, and then execute the operation again.
124-709
[Cause] The document exceeded the maximum number of pages that can be stapled.
[Remedy] Reduce the number of pages, or cancel the stapling setting, and then try printing
again.
124-710
[Cause] The machine cannot output to the output destination specified. A paper size or a
paper type that cannot be output is specified or the output destination fails.
[Remedy] No measure is required. The machine automatically selects the available output
destination. If the paper is not still output from the specified output destination
even after the correct paper size and type is selected, contact your local Fuji
Xerox representative.
125-311
[Cause] An error occurred
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error is not resolved, contact your local Fuji
Xerox representative.
127-210
127-211
[Cause] An error occurred in the communication between the machine and Printer Server.
[Remedy] Unplug the connector cable of the Printer Server, and plug it in again. Switch off
the machine power, make sure that the touch screen is blank, and then switch on
the machine power.
127-213
[Cause] An error occurred in the communication between the machine and Printer Server.
[Remedy] Update the software versions for the machine and the Printer Server.
127-220
127-221
[Cause] An error occurred in the communication between the machine and Printer Server.
[Remedy] Unplug the connector cable of the Printer Server, and plug it in again. Switch off
the machine power, make sure that the touch screen is blank, and then switch on
the machine power.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact your local Fuji Xerox
representative. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
