3 Maintenance
80
Maintenance
3
3) Select [Tools] on the [Services Home]
screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4) Select [System Settings] > [Common
Service Settings] > [Image Quality
Adjustment].
2 Select [Calibration].
3 Select [Screen Type] and [Paper Supply].
Note • The following describes calibration
procedures using Copy Job 1, as an
example.
• For Paper Supply, select the paper tray
on which A4 , A3 , 8.5
x 11" , or
11
x 17" white paper is loaded.
• Make sure that [Target] is set to [Copy &
Print Jobs].
• If [Copy & Print Jobs] is not selected for [Target], calibration is not valid for the mode that
does not correspond to [Target].
4 Select [Start].
Note • The message "Outputting the Calibration
Chart... - Copy Job 1" appears and the
document for calibration (Calibration
Chart) is printed.
5 Align the magenta patch (squares printed at
the top and bottom of the Calibration Chart)
of the printed Calibration Chart against the
left side of the document glass, and load the
chart facing down on the document glass.
Note • Place the Calibration Chart on the
document glass.
To Next Page
Loading...
