Fujitsu PRIMERGY TX1310 M3

TX1310 M3 Upgrade and Maintenance Manual 169
Accessible drives
12.3.1.5 Concluding steps
Ê "Sliding the HDD cage into the chassis" on page 52
Ê "Reassembling" on page 51
Ê "Connecting the power cord" on page 56
Ê "Switching on the server" on page 57
Ê "Reconfiguring the backup software solution" on page 66
Ê "Resuming BitLocker functionality" on page 70
12.3.2 Removing a backup drive
V CAUTION!
Always replace drives to comply with applicable EMC regulations and
satisfy cooling requirements.
12.3.2.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 61
Ê "Removing backup and optical disk media" on page 63
Ê "Verifying and configuring the backup software solution" on page 63
Ê "Shutting down the server" on page 44
Ê "Disconnecting the power cord" on page 45
Ê "Getting access to the component" on page 46
Ê "Extending the HDD cage out of the chassis" on page 47
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver (for removing the PSU)