TX1310 M3 Upgrade and Maintenance Manual 51
Basic hardware procedures
4.5 Reassembling
V CAUTION!
● Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
● In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
● For further safety information, please refer to chapter "Important
information" on page 29.
4.5.1 Installing the front cover
Figure 10: Installing the front cover
Ê Hook the three tabs on the front bezel into the notches in the chassis (1).
Ê Carefully close the front bezel (2). Make sure that all three locking latches
properly engage (3).
To Next Page
Loading...
