TX1310 M3 Upgrade and Maintenance Manual 57
Basic hardware procedures
4.7 Switching on the server
V CAUTION!
● Before switching on the server, make sure the side cover is closed. In
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
● For further safety information, see chapter "Important information" on
page 29.
Ê Connect all peripheral cables to the server.
Figure 17: On/Off button on the front panel
Ê Press the On/Off button to start up the server (1).
Ê Ensure that the power-on indicator is lit white.
I For more information see section "Indicators on the front panel" on
page 226.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
To Next Page
Loading...
