46 Upgrade and Maintenance Manual TX1310 M3
Basic hardware procedures
4.4 Getting access to the component
V CAUTION!
● Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
● In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
● For further safety information, please refer to chapter "Important
information" on page 29.
4.4.1 Removing the side cover
Figure 4: Removing the side cover
Ê Pull up on the locking lever (1).
Ê Open the side cover (2).
Ê Remove the side cover (3).
To Next Page
Loading...
