Fujitsu PRIMERGY TX1310 M3

92 Upgrade and Maintenance Manual TX1310 M3
Hard disk drives (HDDs)
7.4 Replacing a 3.5-inch HDD
V CAUTION!
All HDDs must be uniquely identified so that they can be reinstalled in
their original mounting locations later. If this is not done, existing data can
be lost.
7.4.1 Preliminary steps
Ê "Shutting down the server" on page 44
Ê "Disconnecting the power cord" on page 45
Ê "Getting access to the component" on page 46
7.4.2 Removing the defective 3.5-inch HDD
Ê Remove the HDD, see section "Removing a 3.5-inch HDD" on page 90.
7.4.3 Installing the new 3.5-inch HDD
Ê Install the HDD, see section"Installing a 3.5-inch HDD" on page 86.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less