188 Upgrade and Maintenance Manual TX1310 M3
System board and components
15.3.1.3 Concluding steps
Ê Install all expansion cards, see section "Expansion cards" on page 113.
I Make sure that you reinstall each card in the slot it was located before
the replacement.
Ê "Reassembling" on page 51
Ê "Connecting the power cord" on page 56
Ê Enable TPM in the system board BIOS. Proceed as follows:
Ê Switch on or restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
Ê Select the Advanced menu.
Ê Select the Trusted Computing submenu.
Ê Set the TPM Support and TPM State settings to Enabled.
Ê Under Pending TPM operation, select the desired TPM operation mode.
Ê Save your changes and exit the BIOS.
I For detailed information on how to access the BIOS and modify
settings, refer to the corresponding BIOS Setup Utility reference
manual.
To Next Page
Loading...
