EasyManuals Logo

Fujitsu PRIMERGY TX1310 M3 Upgrade And Maintenance Manual

Fujitsu PRIMERGY TX1310 M3
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34 Upgrade and Maintenance Manual TX1310 M3
Important information
Do not pull on, press hard, or otherwise handle the CD/DVD/BD tray
roughly.
Do not disassemble the optical disk drive.
Before use, clean the optical disk tray using a soft, dry cloth.
As a precaution, remove disks from the optical disk drive when the
drive is not to be used for a long time. Keep the optical disk tray
closed to prevent foreign matter, such as dust, from entering the
optical disk drive.
Hold CDs/DVDs/BDs by their edges to avoid contact with the disk
surface.
Do not contaminate the CD/DVD/BD surface with fingerprints, oil,
dust, etc. If dirty, clean with a soft, dry cloth, wiping from the center to
the edge. Do not use benzene, thinners, water, record sprays,
antistatic agents, or silicone-impregnated cloth.
Be careful not to damage the CD/DVD/BD surface.
Keep the CDs/DVDs/BDs away from heat sources.
Do not bend or place heavy objects on CDs/DVDs/BDs.
Do not write with ballpoint pen or pencil on the label (printed) side.
Do not attach stickers or similar to the label side. Doing so may cause
rotational eccentricity and abnormal vibrations.
When a CD/DVD/BD is moved from a cold place to a warm place,
moisture condensation on the CD/DVD/BD surface can cause data
read errors. In this case, wipe the CD/DVD/BD with a soft, dry cloth
then let it air dry. Do not dry the CD/DVD/BD using devices such as a
hair dryer.
To avoid dust, damage, and deformation, keep the CD/DVD/BD in its
case whenever it is not in use.
Do not store CDs/DVDs/BDs at high temperatures. Areas exposed to
prolonged direct sunlight or near heating appliances are to be
avoided.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX1310 M3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu PRIMERGY TX1310 M3 and is the answer not in the manual?

Fujitsu PRIMERGY TX1310 M3 Specifications

General IconGeneral
Processor cache8 MB
Processor cores4
Processor modelE3-1225V6
System bus rate8 GT/s
Motherboard chipsetIntel® C236
Processor frequency3.3 GHz
Processor cache typeSmart Cache
Processor lithography14 nm
Processor boost frequency3.7 GHz
Processor operating modes64-bit
Number of processors installed1
ECCYes
Internal memory8 GB
Memory clock speed2400 MHz
Internal memory typeDDR4-SDRAM
Maximum internal memory64 GB
HDD size3.5 \
HDD speed7200 RPM
RAID levels0, 1, 10
HDD capacity1000 GB
HDD interfaceSerial ATA III
Optical drive typeDVD-RW
Total storage capacity2000 GB
Maximum storage capacity- TB
Number of HDDs installed2
On-board graphics card modelIntel® HD Graphics 630
LAN controllerIntel® I219
Cabling technology10/100/1000Base-T(X)
Ethernet interface typeGigabit Ethernet
Serial ports quantity-
USB 2.0 ports quantity3
VGA (D-Sub) ports quantity0
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity6
Chassis typeTower
Compatible operating systemsMicrosoft Hyper-V Server 2012 R2 Microsoft Hyper-V Server 2016 Microsoft Windows Server 2012 R2 Datacenter Microsoft Windows Server 2016 Datacenter Microsoft Windows Server 2012 R2 Standard Microsoft Windows Server 2016 Standard Microsoft Windows Server 2012 R2 Essentials Microsoft Windows Server 2016 Essentials Microsoft Windows Server 2012 R2 Foundation Microsoft Windows Storage Server 2012 R2 Standard Microsoft Windows Storage Server 2016 Standard Microsoft Hyper-V Server 2012 Microsoft Windows Server 2012 Datacenter Microsoft Windows Server 2012 Standard Microsoft Windows Server 2012 Essentials Microsoft Windows Server 2012 Foundation SUSE Linux Enterprise Server 12 Red Hat Enterprise Linux 7
Power supply250 W
Power supply input frequency50 - 60 Hz
Redundant power supply (RPS) supportNo
Operating temperature (T-T)10 - 35 °C
CertificationCB, RoHS, WEEE, GS, CE, CSA us, ULc/us, FCC Class A, VCCI:V3 Class A + JIS 61000-3-2, KC, CCC, C-Tick (AS / NZS CISPR 22 Class A)
Sustainability certificatesEPEAT Gold
Weight and Dimensions IconWeight and Dimensions
Depth305 mm
Width180 mm
Height375 mm
Weight14000 g

Related product manuals