Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
226
Annunciations & Alerts
Flight
InstrumentsEIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
AvoidanceAFCS
Additional
FeaturesAnnun/AlertsAppendixIndex
Flight
InstrumentsEAS
Audio and
CNS
Flight
Management
Hazard
AvoidanceAFCS
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
System Message Comments
GEA # 1 INOP: CNFG –
Check GEA software and
configuration.
There is a problem with the GEA 1 software configuration. Check the
configuration. If the problem persists, the system should be serviced.
GEA # 1 INOP: INTRL –
GEA internal fault.
GEA 1 has an internal fault. The system should be serviced.
GEA # 1 INOP: POWER –
Check GEA power.
GEA 1 power is low. Check GEA power. If the problem persists, the system
should be serviced.
GEA # 1 INOP: SENS
CNFG – Check GEA
software and configuration.
There is an error in the GEA 1 software and configuration. Check the
software and configuration. If the problem persists, the system should be
serviced.
GEA # 1 INOP: TEMP
– Check GEA cooling
arrangement.
GEA 1 has insufficient cooling. If the problem persists, the system should
be serviced.
GEA # 1 INOP: VOLT –
Check GEA voltages.
GEA 1 voltage is low. Check GEA voltages.
GEA # 1 INOP: VOLT
EXCIT – Check GEA
Transducer Power Outputs.
GEA 1 transducer power is low. Check GEA transducer power.
GEA1 CONFIG – GEA1
config error. Config service
REQ’D.
The #1 GEA configuration settings do not match those of backup
configuration memory. The system should be serviced.
GEA1 MANIFEST –
GEA1 software mismatch,
communication halted.
The #1 GEA has incorrect software installed. The system should be
serviced.
GEO LIMITS – AHRS1
too far north/south, no
magnetic compass.
The aircraft is outside geographical limits for approved AHRS operation.
Heading is annunciated as invalid.
GEO LIMITS – AHRS2
too far North/South, no
magnetic compass.
The aircraft is outside geographical limits for approved AHRS operation.
Heading is flagged as invalid.
GFC MANIFEST – GFC
software mismatch,
communication halted.
Incorrect servo software is installed, or gain settings are incorrect.
GIA #1 FAN FAIL –
Fan fault, check GIA
temperature.
GIA #1 fan failure. Monitor GIA #1 temperature.
GIA #1 INOP - CRNT –
Check GIA Current.
GIA 1 current is low. The current should be checked.
To Next Page
Loading...
