Brivo OEC 715/785/865/865 Mobile C-Arm X-Ray Product Service Manual
 
2-78 
Operation of UPS 
Display interface 
 
On Line—The UPS is supplying utility power to connected equipment 
Power-Saving—Master and controlled outlets are enabled, saving 
power when the master device goes into sleep or standby mode 
Load Capacity—The load is indicated by the number of sections 
illuminated, one to five. If the load exceeds the rated capacity, the 
Overload symbol will flash off and on. 
Battery Charge—The battery charge level is indicated by the number of 
sections illuminated. When all five blocks are illuminated, the Back-UPS 
is at full charge. When one block is filled, the Back-UPS is near the end 
of its battery capacity, the indicator will flash and the unit will beep 
continuously. 
Overload—The power demand from the load has exceeded the 
capacity of the Back-UPS. 
Event—An event has occurred and the unit needs attention. 
Automatic Voltage Regulation—The unit is compensating for extremely 
low input voltage, but is not using battery power. 
Out—Output voltage. 
System Faults—The system has a fault. The fault number will illuminate 
on the display interface. See “System Faults” on page 4. 
Mute—The audible alarm has been turned off. 
Replace Battery—The battery is not connected or is nearing the end of 
its useful life. Replace the battery. 
On Battery—The unit is supplying battery backup power to the 
connected equipment, it will beep four times every 30 seconds. 
Modes of operation 
Press DISPLAY to scroll through the display screens. 
Estimated runtime in minutes