Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
4-24
Camera Centering Calibration procedure for Brivo OEC 715/785:
1. To have access to the Camera Securing Screws, perform the following.
a. Position the C-arm to Image Intensifier up, Monoblock down.
b. Remove the I.I. cover and cables connected to Camera.
c. Remove the upper counter weight by releasing 4 M4*16 secure screws from II upper
counter balance.
d. Reuse the released 4 M4*16 screws as camera alignment screws, fasten them using
modest torque
To Next Page
Loading...
