GE Brivo OEC 715 - Page 374

Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
6-40
Exception
ID
Error
Warning
Exception
Description
(In system Log)
Message
(Displayed in User Interface)
Diagnosis Reference
0309508
Warning
Start setup
exception
Open Setup exception. Please
restart the system. If this issue
persists, please call for service.
system unknown error
0309509
Warning
Stop setup
exception
Close Setup exception. Please
restart the system. If this issue
persists, please call for service.
system unknown error
0309510
Warning
Read
configuration
file failed
Connectivity configuration
loading failure. Please restart
the system. If this issue
persists, please call for service.
check if configuration file
crashed
0309511
Warning
Init tab page
controller failed
Runtime exception. Please
restart the system. If this issue
persists, please call for service.
system unknown error
0309512
Warning
Read serial
number from
bios failed
Workstation hardware version
access exception. Hardware
information can’t be displayed.
Please restart the system. If
this issue persists, please call
for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0309513
Error
Register CORBA
service failed
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
make sure if omniNames
service failed, any module
initialization failed
0309514
Error
Unregister
CORBA service
failed
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
make sure if omniNames
service failed, check
omniOrb log file
0309515
Error
CORBA sync
notify failed
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
make sure if omniNames
service failed,
CorbaEventChannel
initialization failed
0309516
Error
Subscribe sync
event failed
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
make sure if omniNames
service failed,
CorbaEventChannel
initialization failed
0309517
Error
Unsubscribe
sync event
failed
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
make sure if omniNames
service failed,
CorbaEventChannel
initialization failed