Replacement
7-21
4. Remove all screws of the printer cabinet. Remove the printer cabinet.
5. Remove the screws and disassemble two Workstation handles.
6. Remove the screws on each side and remove the left and right upper side covers.
7. Replace the cover and install them in reverse sequence.
8. Replace Workstation front cover need refer old front cover to affix local language warning labels
in each Multi-language Label Kit.
The torque requirement to fasten the screws that secure the rear and side covers is
2.5Nm.The torque requirement to fasten the screws that secure the front cover is 5.8Nm.
Replace Workstation front cover need order Workstation cover FRU (5075909 for 715,
5075910 for 785, 5075911 for 865) and Multi-language Label Kits in each language,
detailed refer to 7.1 FRU List.
Top Cover
Rear cover must be removed before upper cover can be removed.
1. Remove all screws that secure the front top cover.
To Next Page
Loading...
