Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
7-22
2. Disconnect the cable connected to the
Workstation membrane keyboard control board.
Remove the front top cover.
3. Remove the screws that secure the membrane
keyboard. Remove the membrane keyboard in the
front top cover.
4. Reassemble the membrane keyboard in the new top cover.
5. Remove the screws that secure the rear top cover. Remove the rear top cover.
6. Replace the new top cover kits and install them in reverse sequence.
The torque of the screws that secure the top covers is 2.5Nm.
Down Side Cover
1. Lift up the side of the Workstation carefully and keep the balance of the Workstation.
To Next Page
Loading...
