Replacement
7-27
3. Remove the plate of the wheel. Loose the
screws and then remove the cable pusher.
4. Replace the new parts in steering none brake position and reassemble all the other parts.
5. Move the C-Arm and verify that the C-Arm can move smoothly.
Wheels of Workstation
Brivo OEC 715/785 and Brivo OEC 865 use different Workstation wheels. Brivo OEC 715/785 use universal
wheels with brake. Brivo OEC 865 use central control wheel and non-central control wheels.
For Brivo OEC 715/785 (PN: 5343601)
1. Lift up the side of the Workstation carefully and keep the balance of the Workstation.
2. Remove the down side cover secure screws and remove the down side covers.
3. Remove the workstation wheel by loose the nut.
4. Assemble wheel as above reverse steps.
5. Move the Workstation and verify that the Workstation can move smoothly.
For Brivo OEC 865
Central Control Wheels (5075965)
1. Lift up the side of the Workstation carefully and keep the balance of the Workstation.
2. Loose the screws and remove the down side cover.
To Next Page
Loading...
