GE Brivo OEC 715 - Page 498

Periodic Maintenance
8-11
If lateral brake can’t prevent lateral motion effectively, perform below procedure to
refresh the force of lateral brake.
54N<Force of wigwag brake <90N
Lateral brake PM:
1. Remove screw caps, cover and screws inside.
2. Fasten the screw to refresh the force of brake.
If above step 1/2 can refresh the force, perform below procedure
3. Loose the set screws.
4. Tighten the brake shoe by adjusting the screw adjuster to left in above picture;
5. Check the force of lateral brake and adjust the screw adjuster, until the lateral brake is effective
again.
6. Secure the screw adjuster with the set screws.
7. Reinstall the screws, cover and screw cap which were removed in step1.
Screw cap
Two screws inside
Friction pad
Set
Screw
Set screw inside
Set
Screw