194 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
Figure 3-102. Default Interfaces Configuration Screen
To configure the LAN interface, select the ETH1 or ETH2 (if available - some units only support ETH1).
As shown in the screens below, there are five groups of configuration settings that can be configured:
General ETHx specifics, IPV4, QOS, Filter, and NAT
Interfaces / Add/Delete Interfaces / ETHx ---> Basic Config
Figure 3-103. ETH1 Configuration Screen
Description - User defined identifier for this connection - 0-34 characters
Type - Identifier of the type of interface - Do Not Change
Enabled - Checked indicates Enabled (DEFAULT). Disable will prevent usage.
Eth Phy Rate - Choose the Ethernet speed support setting (DEFAULT ALL)
- Eth 10Mb Half
- Eth 10Mb Full
- Eth 100Mb Half
- Eth 100Mb Full
Vlan Mode - Virtual LAN Setting. (Ethernet port Security / Port-based Authentication
Understanding
Orbit devices support Ethernet-port security using port-based authentication. Port-based authentication
blocks traffic on the front Ethernet port(s) until a RADIUS server determines that the device connected to
the port is allowed to communicate on the network. The Orbit must have a route to the RADIUS server
using another network channel in order for authentication to work. Port-based authentication can be
enabled in either EAP (Extensible Authentication Protocol) mode or MAB (MAC Authentication Bypass)
mode. Both modes require the use of RADIUS server.
To Next Page
Loading...
Need help?
General
