MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 307
On the Web UI, on the SNMP main screen scroll down on each section and set/verify the parameters.
These parameters are nested as shown in the example below:
Click on all-rights to see member and access definitions:
Filling in the VACM Group parameter values can be accomplished via the CLI using the following
commands:
% set services snmp vacm group all-rights member public sec-model [v1 v2c ]
% set services snmp vacm group all-rights access any no-auth-no-priv read-view internet
Click “Save” on the Web UI. 3.
Via the CLI using the following commands:
% commit
Configuring the SNMP agent for v3-only operation (w/ Authentication and
Encryption)
The example below assumes SNMP agent has factory default configuration (see section “Default
Configuration on Page 303”).
Disable v2c and enable v3 1.
To Next Page
Loading...
