MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 357
The ‘General’ panel shows the general status of the service i.e. whether it is running or not. The ‘Data’
panel displays the GPS location information as reported by the GPS data source. The ‘Sources’ panel
displays the GPS data sources detected in the system. In the above example, GPS service is collecting
data from the GPS receiver in the cellular module.
Using CLI
> show services gps
services gps status fix-mode 3d-fix
services gps status time 2015-06-08T18:27:44.000Z
services gps status latitude 43.11787493300000
services gps status longitude -77.61123601700000
services gps status altitude 588.5826816558838
services gps status speed 0.000000000000000e+0
services gps status heading 0.000000000000000e+0
NAME DEVICE
------------------------------
SLOT1-CELL-GPS /dev/ttyUSB1
Dynamic DNS 3.8.23
Understanding
The unit supports Dynamic DNS (DDNS) service that enables update of the dynamic address of an
interface (typically, cellular WAN interface) on the unit against a pre-registered fully qualified domain
name (FQDN) (for example, pump1.dyndns.org) with a DDNS provider. The update occurs when the
interface address changes as well as periodically. This enables a host or application to contact a remote
unit using a fixed domain name even if the IP address of the remote unit is dynamic.
There is built in support for DynDNS.com and No-IP.com DDNS providers. The service also supports
user specified URL for updating DDNS providers that do not have built-in support.
Configuring
Navigate to Services->DDNS Service--> Basic Config
To Next Page
Loading...
Need help?
General
