MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 193
> show interfaces-state
interfaces-state interface Bridge
type bridge
admin-status up
oper-status up
if-index 1
phys-address 00:06:3d:07:96:82
statistics discontinuity-time 2014-02-12T14:29:35-05:00
statistics in-octets 259644036
statistics in-unicast-pkts 3188877
statistics in-multicast-pkts 0
statistics in-discards 4126
statistics in-errors 0
statistics out-octets 737353
statistics out-unicast-pkts 1135
statistics out-discards 0
statistics out-errors 0
ipv4 forwarding true
ipv4 mtu 1500
PREFIX
IP LENGTH ORIGIN
-----------------------------------------------------
10.10.10.141 23 static
LINK LAYER
IP ADDRESS ORIGIN STATE
-----------------------------------------------------
10.10.10.109 00:11:11:e0:2e:70 dynamic stale
10.10.10.98 80:c1:6e:f0:3b:7a dynamic reachable
LAN 3.8.2
Understanding
The unit has external Local Area Network (LAN) ports (ETH1/2 ports) that can be used to connect to a
local (wired) LAN. It supports both IPv4 and IPv6 addresses and may be assigned multiple IP addresses.
The LAN port can be assigned static IP addresses or a dynamically allocated address can be assigned
using DHCP.
NOTE The LAN port should be assigned IP addresses only if it is a routed interface (that is, not in a
bridge).
Configuring
From the Interfaces screen the status may be displayed by clicking on the interface and scrolling down to
the statistics information:
Navigate to: Interfaces / Add/Delete Interfaces
To Next Page
Loading...
