104 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
- 500kbps - Theoretical throughput of 500 kbps (DEFAULT)
- 1000kbps - Theoretical throughput of 1000 kbps with narrow bandwidth
- 1000Wkbps - Theoretical throughput of 1000 kbps with higher sensitivity
- 1250kbps - Theoretical throughput of 1250 kbps
- Auto - While the AP must pick a fixed modem, in this mode the remote will scan through
all modems and find the one with the strongest signal. Each modem scan can take a
few minutes which means worst case it could take up to 5 modem changes before finding
the correct modem. The unit will continue to scan until it connects with an AP.
Device Mode - Sets the role the radio will assume in the network.
- Remote (DEFAULT)
- Access Point
- Store and Forward
Network Name - The name of the network. Used to control what networks is connected to.
Valid values: 1 to 31 letters (DEFAULT = mds-nx). The network name string is used to
identify the logical network the device as a member of a network. If the network name does
not match, the device will log an event, to identify network name collisions.
Data Compression – Over the air compression
- lzo - Compresses the over the air traffic with the LZO algorithm
- none - No data compression (DEFAULT)
Header Compression – Disabled by DEFAULT. Enable/disable over the air robust header
compression. This feature compresses IP headers to improve system performance, and is most
useful in applications that rely on IP packets with small payloads, such as terminal server
operations or MODBUS polling. This setting must match on each radio (Remote and AP).
Power - The transmit power of the radio. Valid values are: 20—30 dBm –DEFAULT =30dBm
Figure 3-48. ISM 900 (NX) Remote EAP Security Configuration
To Next Page
Loading...
Need help?
General
