GE MDS ORBIT ECR User Manual

162 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
system support-package generate-status percent-complete 100
3.7 System Configuration and Setup
Date, Time and NTP 3.7.1
Understanding
The date and time can be set on the unit using a manually configured value or automatically via Network
Time Protocol (NTP). The NTP settings take precedence over the manual settings. If NTP is enabled, then
the user will not be able to set the date and time manually.
The Orbit MCR provides the admin user the ability to increase the complexity of the configured user
login passwords. User passwords can be configured to have a minimum length, a minimum amount of
lower-case letters, a minimum amount of capital letters, a minimum amount of numeric characters and a
minimum amount of non-alpha numeric values.
Configuring
Manual Setting of Date, Time and Timezone
To manually set the System Clock date and time on the webUI - Navigate as shown and set the date
(using the calendar) , time (using the slider shown below) and timezone (offset from GMT) - Navigate to
System / Time ---> Actions / Set Current Datetime:
Figure 3-83. Set DateTime Screen
For setting the time use the sliders;
Figure 3-84. Set Date and Time Sliders Screen

GE MDS ORBIT ECR Specifications

General

Brand	GE
Model	MDS ORBIT ECR
Category	Network Router
Language	English