MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 227
Apply the source NAT rule-set to the public interface. 3.
To perform the masquerading shown in the example network in Understanding above, a source NAT rule
would be created and applied to the cell interface. The following example will illustrate the necessary
steps in three ways: Using the Source NAT wizard, through the web UI, and via the CLI.
Using the Source NAT Wizard
The Source NAT Wizard allows the creation or editing of Source NAT rule sets. First, navigate to
Wizards and click Source NAT/Masquerading from either the navigation bar or the main Wizards page.
Figure 3-138. Configuration Wizards Menu
The Source NAT Introduction page appears.
To Next Page
Loading...
