44 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
LN Security – Secure Licensed Narrowband link pre-shared key or EAP-TLS/RADIUS using 9.
certificates.
Event Logging – Securely send event logs to central SYSLOG server by configuring SYSLOG over 10.
TLS.
PKI/Certificate Management – Generate/upload private keys/certifications for use in certificate 11.
based security setup.
Tamper Detection – Enable tamper detection to detect unauthorized device enclosure removal and 12.
physical movement from authorized install site.
3.2 Preconfigured Settings
The GE MDS factory configuration establishes typical settings based on the types of modules ordered.
The intent is to provide as much out-of-box functionality as possible. For example, in WiFi/Cell
configurations, the unit is configured as a WiFi hotspot.
The Orbit MCR is highly configurable to meet field requirements, but comes preconfigured as
follows:
- The COM and USB ports are enabled for local console operation.
- When applicable, interfaces are preconfigured as members of a bridge.
- A DHCP server is enabled for WiFi clients and the Ethernet LAN ports.
Units are configured with a set of pre-defined defaults set by the factory.
- Default Ethernet IP address 192.168.1.1
- Firewall/NAT/DNS proxy enabled
- DHCP server enabled
Other defaults
WiFi (hotspot):
- Set as Access Point (AP)
- SSID = GEMDS_<SERNUM> SERNUM refers to the unit’s serial number, printed on a
chassis sticker.
- The Ethernet ports are bridged with the WiFi AP.
- SSID broadcast enabled
- Security = WPA2-PSK, CCMP with passphrase: GEMDS_ORBIT
Cellular modem:
- 4G Cellular interface is enabled by default since network can enable connectivity on default
APN.
- 3G Cellular interface is disabled by default since it requires carrier specific APN to be
configured.
ISM Unlicensed 900 MHz radio (NX915):
- Radio Mode set to Remote
- Modem Mode 500kbps
- Power at 30 dBm
Licensed Narrowband radio (LN400/LN900):
To Next Page
Loading...
